![]() – Disconnect the recoil spring connector from its connection point (where it meets with your pressure washer’s pull cord unit). ![]() With the shield removed, you’ll be able to access the recoil spring located at the top of your pressure washer’s housing. – Loosen two screws holding down the plastic shield around your pressure washer’s pull rope unit (you may need a screwdriver to do this). – Unscrew the spray gun hose connector by turning it counterclockwise with a socket wrench. Then, pull the nozzle away from the housing and pull its recoil cord out of its recoiler groove. If you do want to purchase a new pressure washer hose, then click here to browse our selection! Take apart the recoil mechanism – After setting aside the spray gun and pressure washer hose, here’s how you can disassemble your pressure washer’s pull cord unit: (Before working on a gas powered pressure washer, remove the spark plug to ensure no power will cause a problem with safety) With that being said, if you don’t want to replace your entire pressure washer pull cord unit just yet, then please follow the steps listed below for fixing the recoil mechanism. If you have a pressure washer hose, it might be worth replacing it with a new one – as they can wear out over time and cause your machine to start malfunctioning. It’s a simple fix that will get your pressure washer working like new again! Here are the steps you’ll need to follow:ĭisassemble the spray gun and/or pressure washer hose – If either of these components is clogged up with debris, then it might be preventing your pressure washer’s recoil mechanism from working properly. So How Do I Fix My Pressure Washer Pull Cord If It Gets Stuck?Īs you may have figured out from the above troubleshooting list, getting your pressure washer’s recoil mechanism working properly is key to preventing the pull start cord from getting stuck. Clogged spray gun and/or hose – When debris builds up within your pressure washer’s recoil mechanism, this can clog it up so that you can’t fully retract your pull cord. If it becomes worn out, then your pressure washer will have a difficult time retracting its pull cord all the way back into its housing. ![]() This might be due to the following issues:Ī worn-out spring – The spring is responsible for retracting the pressure washer’s pull start cord after you’ve used it. If you’re going through pressure washer pull cord locks on a weekly basis or more often, then chances are your pressure washer has an issue with its recoil mechanism. It’s important to keep in mind that this is a pretty common problem.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |